Wastewater Lifting Unit

Wastewater Lifting Unit
Product Introduction:
Wastewater Lifter offers extremely low inlet, multiple sizes to meet the wastewater lifting of family homes without feces, suitable for shower fixtures, laundry rooms, pedestal basins, offers a choice of up to 3 inlets to meet different drainage needs.
Send Inquiry
Description
Technical Parameters

Introduction

The Wastewater Lifting Unit is a kind of equipment used to lift waste water below the sewer or far away from the municipal pipe network to the drainage network. It is widely used in basements, subway stations, underground shopping malls and other places.

 

Working principle

Wastewater collection
Wastewater enters the water collection tank of the lifting device through the water inlet. The water collection tank is usually made of stainless steel, which has good corrosion resistance and sealing. The box is designed to be fully enclosed, with an exhaust pipe on the top to prevent odor leakage. There is a sewage outlet at the bottom to facilitate the emptying of sewage during maintenance. There is also a liquid level gauge in the box to monitor water level changes.

 

Solid-liquid separation
The water collection tank is equipped with a solid-liquid separation device, which is usually a stainless steel interception net. When wastewater containing solid debris enters the equipment, solid debris with a diameter greater than 10 mm is intercepted and retained in the solid-liquid separator. The separated sewage flows into the water collection tank. When the water pump is started, the pressurized water flow enters the solid-liquid separator through the backwash port, removes the solid debris, and lifts and discharges it to the outdoor pipe network. Each backwash can discharge all the debris in the solid-liquid separator without residue.

 

Pump start and drainage
When the water level in the water collection tank reaches the starting water level, the liquid level switch sends a signal to start the water pump. The water pump sucks sewage from the water collection tank, and after being pressurized by the pump body, it is discharged to the outside through the check valve. When the water level drops to the stop level, the water pump stops working and completes a working cycle. When the water volume is large or the equipment fails, the standby pump is automatically started to ensure the continuous operation of the system. When the water level reaches the alarm level, the equipment will send a sound signal or transmit the fault to the remote control room.

 

Automatic control and safety protection
The entire sewage lifting device adopts a fully automatic control system. When the water level reaches the high liquid level, the water pump is started to drain, and when it reaches the low liquid level, the pump is stopped. If the water flow rate of the tank is large, the single pump is too late to drain, and the device will start another water pump to ensure that the sewage in the water tank will not overflow. The equipment is also equipped with overcurrent and overload protection functions to ensure the safe and stable operation of the system.

image001

 

 

image005

Mini lift300+1

 

Packaging Information

Quantity/Carton: 1PCS/CTN
Gross/Net Weight: 4.9/4 KGS
Packing Size: 36X 24X 20CM
20ft Cabinet: 1766 PCS
40 Feet Cabinet: 3656 PCS
40ft Cabinet: 4172 PCS

image003

Mini lift300+1

 

Specification

Voltage: 220V-240V 50HZ
Power: 300W
Insulation grade: F
Speed: 2850RPM
Noise level: < 45db
Protection grade: IP55
Start water level: 55mm
Stop water level: 25mm
Maximum flow rate: 100(L/min)
Maximum head: 6.5M

image007

 

image011

Mini lift550+3

 

Packaging Information

Quantity/Carton: 1PCS/CTN
Gross/Net Weight: 8.5/7.5 KGS
Packing Size: 46.2X 25.4X 35.1CM
20ft Cabinet: 756 PCS
40 Feet Cabinet: 1556 PCS
40ft Cabinet: 1765 PCS

image009

Mini lift550+3

 

Specification

Voltage: 220V-240V 50HZ
Power: 550W
Insulation grade: F
Speed: 2850RPM
Noise level: < 45db
Protection grade: IP55
Start water level: 65mm
Stop water level: 35mm
Maximum flow rate: 150(L/min)
Maximum head: 9.5M

Highest temperature: 90°

image013

 

 

image017

Mini lift600+3

 

Packaging Information

Quantity/Carton: 1PCS/CTN
Gross/Net Weight: 7.5/6.5 KGS
Packing Size: 46.2X 25.4X 35.1CM
20ft Cabinet: 756 PCS
40 Feet Cabinet: 1556 PCS
40ft Cabinet: 1765 PCS

image015

Mini lift600+3

 

Specification

Voltage: 220V-240V 50HZ
Power: 600W
Insulation grade: F
Speed: 2850RPM
Noise level: < 45db
Protection grade: IP55
Start water level: 65mm
Stop water level:35mm
Maximum flow rate: 150(L/min)
Maximum head: 9.5M

image019

 

 

Hot Tags: wastewater lifting unit, China wastewater lifting unit suppliers, factory

Send Inquiry
ONE-STOP SERVICE
Warmly Welcome Your Inquiries And Visiting
contact us